Application & Preparation

Preparation is the most important step. Follow these steps:

  1. Wash thoroughly using pH-neutral shampoo.
  2. Decontaminate with iron remover and clay bar.
  3. Paint correction process  in which do cut & polish to remove swirl marks, light scratches. (optional but recommended).
  4. Wipe with IPA (Isopropyl Alcohol) to remove oils.
  5. Make sure the surface is completely clean, cool, and dry before coating.

  1. Take the applicator pad and apply a few drops of coating onto it.
  2. Work on small sections using a cross-hatch pattern (up-down, left-right).
  3. Wait for the “flash time” 1-2 minutes depending on temperature.
  4. Wipe off the excess using a clean microfiber towel.
  5. Repeat the process panel by panel.

  1. Initial Cure: 12–24 hours (avoid water exposure).
  2. Full Cure: 5–7 days (avoid washing, chemicals, or pressure washing).

Aftercare & Maintenance

To keep your coating performing at its best:

  1. Wash with pH-neutral shampoo only.
  2. Use a microfiber wash mitt.
  3. Avoid automatic car washes.
  4. Apply ceramic booster or top-up every 2–3 months (optional).
  5. Remove bird droppings or bug splatters immediately.

Polishing will remove or reduce the coating. If you need to polish, a re-application of the ceramic coating is recommended.

Coatings provide minor scratch resistance, but not complete scratch-proofing. They mainly protect against swirl marks and light abrasions.

Product & Usage

A 50ml bottle is usually enough for:

  1. 1 sedan: 30–40ml
  2. 1 SUV: 40–50ml
  3. Larger vehicles may need more

Keep it in a cool, dark place, tightly sealed. Avoid heat and direct sunlight.